The rugged and lightweight MC 836 shotgun microphone has been designed to meet the demands of ENG and EFP applications. Due to its acoustical characteristics it is also suited for film applications. The directional polar pattern helps to suppress lateral and background noise.

The microphone operates according to the pressure gradient/line transducer technique. A switchable low frequency roll-off eliminates unwanted low frequencies at a cut-off frequency of 90 Hz. An integrated footfall sound insulation avoids the transmission of noise below 40 Hz.

To avoid wind noise when used outdoors, a wind shield must be used. The microphone can be operated with a phantom power supply of 11 - 52 V.

Features

Lobe/Cardioid polar pattern
Very wide frequency response
Low frequency roll-off switch
Phantom power supply 11 - 52 V

Application

Interviewing
Film recording
Live recording

• Transducer type
  Condenser
• Operating principle
  Pressure gradient/line transducer technique
• Polar pattern
  Lobe/cardioid
• Open circuit voltage at 1 kHz (0dB = 1V/Pa)
  30 mV/Pa
• Nominal impedance
  180 ohm
• Load impedance
  1000 ohm
• Connector
  3-pin XLR
• Length
  248mm
• Shaft diameter
  21mm
• Head diameter
  21mm
• Weight without cable
  116 g
• Frequency response
  40 - 20,000 Hz
• Max. SPL at 1 kHz
  > 130 dB
• A-weighted equivalent SPL
  approx. 13 dB
• Power supply
  11 - 52 V phantom power
• Current consumption
  4.3 mA
• Variant
  MC 837